ABMA 104:2016 pdf free

ABMA 104:2016 pdf free.Rolling bearings一Thrust bearings一Boundary dimensions, general plan
This International Standard specifies preferred boundary dimensions for single- direction and double-direction thrust bearings with flat back faces.
In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24.
Guidelines for the extension of this International Standard for single-direction thrust bearings are given in Annex A.
NOVE Boundary dimensions for aligning thrust bearings (none flat back faces) and aligning seat washers are given in ISO 20516.[2]
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 582, Rolling bearings一Chamfer dimensions一Maximum values
ISO 5593, Rolling bearings一Vocabulary
ISO 15241, Rolling bearings一Symbols for physical quantities
For the purposes of this document, the terms and definitions given in ISO 5593 and the following apply.
thrust rolling bearing with flat back faces intended to support axial load in one direction only
thrust rolling bearing with flat back faces intended to support axial load in both directions
For any new dimension not numerically determined in this International Standard, the following guidelines should be used. The formula given for outside diameter and height should not, however,be used for definite determination of the boundary dimension values; they may often require to be modified in order to maintain the continuity of this International Standard to obtain suitable bearing proportions and to permit selection of preferred dimensions.Accordingly, any new dimensions will have to be approved by ISO.
Bore diameters, d, of shaft washers, above d = 500 mm, should be selected from the R 40 series of preferred numbers given in ISO 3.[1]
Bore diameters of shaft washers already appearing in this International Standard should be chosen for preference.ABMA 104 pdf free download.